LT-LD80200 Laser Diode Technical Data
● Features
-Low Operating Current
-High Efficiency
-High reliability
-High Precision Package
-Infrared Light Output : λp=808nm
-Package Te : TO-18(Ø5.6mm)
-Built-in Photo Diode for Monitoring Laser Diode
● Absolute Maximum Rating at TC=25℃
Items | Symbol | Rating | Unit |
Optical Output Power | PO | 200 | mW |
LD Reverse Voltage | VLDR | 2 | V |
PD Reverse Voltage | VPDR | 30 | V |
PD Forward Current | IPDF | 10 | mA |
Operation Temperature | TOP | -10 ~ +40 | ℃ |
Storage Temperature | Tstg | -40 ~ +80 | ℃ |
● Electrical and Optical Characteristics at TC=25℃
Items | Symbol | Min | T. | Max | Unit | Condition |
Lasing Wavelength | λp | 805 | 808 | 811 | nm | PO=200mW |
Threshold Current | Ith | - | 50 | 60 | mA | - |
Operating Current | Iop | - | 240 | 300 | mA | PO=200mW |
Slope Efficiency | η | 0.7 | 0.95 | 1.1 | mW/mA | PO=150-200mW |
Monitor Current | Im | 0.1 | 0.5 | 1.0 | mA | PO =200mW |
Operating Voltage | Vop | - | 1.8 | 2.2 | V | PO=200mW |
Parallel divergence angle | θ‖ | 6 | 8 | 10 | deg | PO=200mW |
Perpendicular divergence angle | θ⊥ | 32 | 36 | 40 | deg | PO=200mW |
Parallel FFP deviation angle | △θ‖ | - | - | &plun;2.5 | deg | PO=200mW |
Perpendicular FFP deviation angle | △θ⊥ | - | - | &plun;2.5 | deg | PO=200mW |
Emission Point Accuracy | △X,△Y,△Z | &plun;60 | µm | |||
Astigmati | As | - | 11 | 15 | µm | PO=200mW,NA=0.4 |
● 說明：
1、注意：該激光二管發射的激光為不可見光，有可能對人眼造成傷害。激光管工作時，嚴禁直接注視其端面。
2、激光管需要合適的驅動電源，瞬時反向電流不能過 25μA，反向電壓不能過 2V，否則會損壞激光管。
接通電源前先插好激光管，電源初始輸出電壓應為，電流調節時應緩慢增加或減少，電流沖擊損壞激光管。
測試激光管：或拔起激光管須在斷電后進行。切勿帶電插/拔激光管，否則激光管將會損壞、失效。
3、激光管應當存放或工作于干燥環境，以結露，結露會損壞激光管。
4、在較高溫度下工作，會閾值電流，降低轉換效率，加速激光管的老化。
5、輸出功率高于指定參數工作，會加速激光管老化。
6、激光管需要充分散熱或在制冷條件下使用。
7、激光二管屬于靜電敏感器件，應做好靜電措施，在人體有良好接地的情況下方可拿取，否則激光管很容易被靜電擊穿，造成激光管失效。靜電可配帶靜電手腕帶。
"
